"Our own heart, and not other men's opinion, forms our true honor."
                -- Samuel Taylor Coleridge

Author Topic: Help me decide on a shield!  (Read 15225 times)

Leganoth

  • Forum Follower
  • ***
  • Posts: 343
Re: Help me decide on a shield!
« Reply #15 on: 2011-08-26, 07:13:57 »
What about the Teutonic  Heater Shield 22 x 34 Stock #30107 $50.00. I little more but ready to go and matches your tabbard. On this subject, what is best to paint these with. Note it will be non combat only for show at ren faires.

OOOOO!! Good spot sir ecox!! I didnt see that one!! If its not the right size/style i could just paint one of the blanks correct?

Sir Edward

  • Forum Admin
  • Commander of the Order
  • Forum Veteran
  • *****
  • Posts: 9,340
  • Verum et Honorem.
    • ed.toton.org
Re: Help me decide on a shield!
« Reply #16 on: 2011-08-26, 13:36:29 »

I think it depends on how durable you want it to be, and how period of a look you want. I think flat acrylics or oil-based paints might get the best period look, as compared to enamels and spray paints. But the latter will be much more durable. And spray-paint with stencils is pretty easy if you're not good with a brush.

But the hardest thing about spray and a stencil is that the paint tends to puff under the stencil, so it's hard to get sharp edges unless you use a stencil adhesive. The adhesive sprays into the underside of the stencil, and sticks it in place. But it's non-permanent (like the adhesive on clear scotch tape), and peels off.

I did this on my shield, and because of the curvature, the stencil still popped up on me, and I still got excess paint. I cleaned it up with an x-acto knife, lightly scraping off the paint I didn't want.

But if you know what you're doing with a brush (specifically how to brush without leaving ugly streaks), you can go that route as well.
Sir Ed T. Toton III
Knight Commander, Order of the Marshal

( Personal Site | My Facebook )

Sir James A

  • Weapons & Armor addict
  • Knight of the Order
  • Forum Veteran
  • ****
  • Posts: 6,043
Re: Help me decide on a shield!
« Reply #17 on: 2011-08-27, 03:26:55 »
That is what everyone is saying to buy, Sir James  :)

Id go with that one too

I was being sarcastic / joking. :)
Knight, Order of the Marshal
Sable, a chevron between three lions statant Argent

Leganoth

  • Forum Follower
  • ***
  • Posts: 343
Re: Help me decide on a shield!
« Reply #18 on: 2011-08-27, 20:18:43 »
Anyways subject of armor the cuirass i was going to get is 18 guage steel, is that thick thin strong or what

Sir Patrick

  • Knight of the Order
  • Forum Acolyte
  • ****
  • Posts: 1,647
  • Nex pro inhonesto, Deus pro totus.
    • The Order of the Marshal
Re: Help me decide on a shield!
« Reply #19 on: 2011-08-28, 00:55:32 »
I painted mine with acrylics and then top-coated with three coats of water-based, flat polyurethane.  I used painter's tape to do the chevron, but I free-handed the ciquefoils and ermines.  One word of advice:  prime the whole thing, paint the charges first, then fill in the background (keeps the base color from bleeding through).
Gules, a chevron argent between three cinquefoils ermine.
"Better to live one day as a lion, than a thousand as a lamb."
Knight, Order of the Marshal

Sir Matthew

  • Squire of the Order
  • Forum Acolyte
  • ***
  • Posts: 603
Re: Help me decide on a shield!
« Reply #20 on: 2011-08-28, 14:04:29 »
Anyways subject of armor the cuirass i was going to get is 18 guage steel, is that thick thin strong or what
That is very thin, if you are going for looks and faire wear it should be fine. I would not wear it for any sort of combat though. My Peascod is 14 gauge on the breast and 16 on the back and tassets. With steel guage, the smaller the number, the thicker it is.

Leganoth

  • Forum Follower
  • ***
  • Posts: 343
Re: Help me decide on a shield!
« Reply #21 on: 2011-08-28, 20:23:29 »
Anyways subject of armor the cuirass i was going to get is 18 guage steel, is that thick thin strong or what
That is very thin, if you are going for looks and faire wear it should be fine. I would not wear it for any sort of combat though. My Peascod is 14 gauge on the breast and 16 on the back and tassets. With steel guage, the smaller the number, the thicker it is.

Well i doubt i can find a good breastplate/backplate sold as one for under 200 dollars

Sir William

  • Cogito ergo sum
  • Knight of the Order
  • Forum Veteran
  • ****
  • Posts: 7,154
Re: Help me decide on a shield!
« Reply #22 on: 2011-08-29, 13:25:39 »
A breastplate by itself, you can, Leganoth.  Besides, you wouldn't have seen a full cuirass prior to the 15th Century anyways if I'm not mistaken, and you did say you were shooting for 14th C?
The Black Knight, Order of the Marshal
'Per Pale Azure and Sable, a Chevron counterchanged fimbriated argent.' 
“Pride makes a man, it drives him, it is the shield wall around his reputation.  Men die, but reputation does not.â€

Sir Edward

  • Forum Admin
  • Commander of the Order
  • Forum Veteran
  • *****
  • Posts: 9,340
  • Verum et Honorem.
    • ed.toton.org
Re: Help me decide on a shield!
« Reply #23 on: 2011-08-29, 16:54:05 »

If you're aiming for 14th C, simple globose breastplates started appearing in the middle of the century. These can actually be pretty affordable. In fact, one cheap way to do it is to get the GDFB breastplate, and remove the plackart (the lower plate), and it looks like a decent globose breastplate.
Sir Ed T. Toton III
Knight Commander, Order of the Marshal

( Personal Site | My Facebook )

Sir William

  • Cogito ergo sum
  • Knight of the Order
  • Forum Veteran
  • ****
  • Posts: 7,154
Re: Help me decide on a shield!
« Reply #24 on: 2011-08-29, 18:01:31 »
I've seen a few used ones going for under $200 on armour archive, 16ga simple globose style.
The Black Knight, Order of the Marshal
'Per Pale Azure and Sable, a Chevron counterchanged fimbriated argent.' 
“Pride makes a man, it drives him, it is the shield wall around his reputation.  Men die, but reputation does not.â€

Sir James A

  • Weapons & Armor addict
  • Knight of the Order
  • Forum Veteran
  • ****
  • Posts: 6,043
Re: Help me decide on a shield!
« Reply #25 on: 2011-08-29, 19:15:04 »
Cet at Rough From The Hammer has very cheap globose breastplates, hand made.
Knight, Order of the Marshal
Sable, a chevron between three lions statant Argent

Sir Wolf

  • He Who is Not to be Named
  • Knight of the Order
  • Forum Veteran
  • ****
  • Posts: 5,389
  • i have too many hats
    • man e faces

Lord Dane

  • The Hound, Hunter, and Hammer of Justice
  • Knight of the Order
  • Forum Acolyte
  • ****
  • Posts: 1,900
  • Selflessness, Service, Justice.
Re: Help me decide on a shield!
« Reply #27 on: 2012-08-11, 02:20:32 »
I'm going to disagree with the group and say go with the 22x34 heater shield.

Finally, a non-conformist speaks his mind against the masses. Huzzah to Sir James. I like the individuals in the group :)
"Fides, Honos, Prudentia, Sapiencia" (Faith, Honor, Prudence, Wisdom)
"Fiat justitia ruat caelum" (Let justice be done)

Sir James A

  • Weapons & Armor addict
  • Knight of the Order
  • Forum Veteran
  • ****
  • Posts: 6,043
Re: Help me decide on a shield!
« Reply #28 on: 2012-08-11, 19:10:41 »
I'm going to disagree with the group and say go with the 22x34 heater shield.

Finally, a non-conformist speaks his mind against the masses. Huzzah to Sir James. I like the individuals in the group :)

It was a sarcastic post on my part. Four people before me recommended the same thing. ;) We're an interesting group, we are.
Knight, Order of the Marshal
Sable, a chevron between three lions statant Argent

Lord Dane

  • The Hound, Hunter, and Hammer of Justice
  • Knight of the Order
  • Forum Acolyte
  • ****
  • Posts: 1,900
  • Selflessness, Service, Justice.
Re: Help me decide on a shield!
« Reply #29 on: 2012-08-11, 20:28:47 »
I'm going to disagree with the group and say go with the 22x34 heater shield.

Finally, a non-conformist speaks his mind against the masses. Huzzah to Sir James. I like the individuals in the group :)

It was a sarcastic post on my part. Four people before me recommended the same thing. ;) We're an interesting group, we are.

That you are. :) Plus, you got mad building skills, Sir James. I raise my stein to ya!! Let's throw down some in knightly fashion til we hit the floor.
"Fides, Honos, Prudentia, Sapiencia" (Faith, Honor, Prudence, Wisdom)
"Fiat justitia ruat caelum" (Let justice be done)