You'll need:
A SLO with a hard scabbard.
A dremel tool with a cutting wheel or hacksaw.
A kit of quick hardening epoxy.
Cut the blade off approximately 3" from the crossguard and another cut approximately 6" from the tip.
Liberally smear the epoxy onto the top 6" section blade and drop it down into the scabbard.
Bang the scabbard a few times to ensure the blade is all the way in.
- This is your counterweight for the hilt.
Next liberally smear epoxy onto the 3" section of blade with the hilt and insert it into the scabbard.
Let it setup overnight and it should be ready for MDRF!
You will then have a Maryland 'special'!