"Many of life's failures are people who did not realize how close they were to success when they gave up."
                -- Thomas Edison

Author Topic: printing off a pattern  (Read 8020 times)

Sir Wolf

  • He Who is Not to be Named
  • Knight of the Order
  • Forum Veteran
  • ****
  • Posts: 5,389
  • i have too many hats
    • man e faces
printing off a pattern
« on: 2009-03-14, 12:52:45 »
http://www.mcbishop.co.uk/jrmes/pattern.pdf

i am having some issues getting this pattern to print. i would liek it to stay 1 to 1 scale. i tried to print but couldn't get it to do so in sections, it just printed the center of the page.

HELP?

Sir Matthew

  • Squire of the Order
  • Forum Acolyte
  • ***
  • Posts: 603
Re: printing off a pattern
« Reply #1 on: 2009-03-15, 15:45:09 »
You might try copy and paste each piece into a seperate page and then printing each page.  Although thinking on that as I type it, I suppose 1 to 1 ratio would make each armor piece larger than a single page, and thus probably  not really solve you problem at all.  I guess in the end I have been no help at all.  Sorry.  I will think on this more, but at this moment I too am stumped.