Main > The Workshop

14th Century Gauntlets - Wisby Type 1

(1/4) > >>

Sir Rodney:
This project is the result of wanting a pair of historically inspired gauntlets and not having the funds necessary to purchase a pair.

I’ve decided to attempt the Wisby Type 1 finger gauntlets as the period is correct (for me) and they look very interesting.

A photograph of the original and construction tips contained in Techniques of Medieval Armour Reproduction, The 14th Century (TOMAR) will be my guide.

Sir Rodney:
A careful tracing of my hand will provide the necessary finger measurements.

I’m using 16 gauge mild steel and a (knockoff) Beverly shear.  Each piece is carefully cut and checked against the tracing.

Sir Rodney:
The sharp edges are then ground off and a primary sanding is done with 600 grit paper on a drum wheel.

[Always, always, always use proper eye protection, sturdy gloves and proper footware in the shop, especially when grinding.  We've all heard this a million times and yet I've still managed to injure myself many times due to my own stupidity.  It's always that last minute touch up that flings a burr into your eye. :o ]

The finger plates are curled by beating them into a female form (made from ¾ inch pipe cut in half) with a male form (a ½ diameter pipe).

The knuckles plates are formed with a cheap doming block found at Harbor Freight stores.

Sir Rodney:
Four complete fingers have been formed to date.  I’ll provide updates at each stage of construction.  Enjoy!

Sir Wolf:
wow awesome man!

Navigation

[0] Message Index

[#] Next page