Main > The Armoury
My project this month (Warning bad drawing here)
Leganoth:
--- Quote from: The Red Knight on 2011-09-06, 04:35:08 ---I've only seen them in round. They come in various strengths. I got mine at Hobby Lobby. I used four 1/2 inch #10 strength ones to secure my griffen crest. I drilled some 1/2 inch holes into the underside of the crest, packed in a little plumbers epoxy putty, and then shoved the magnets in the holes. Haven't had any trouble with them pulling off the crest. For wings, I'd try two 1/4 inch magnets per side (since the helm is curved). As for stability, with #10 rare earth magnets, I practically have to pry my crest off!
--- End quote ---
So this would be good? http://www.kjmagnetics.com/proddetail.asp?prod=DX04
Sir Rodney:
--- Quote ---Each of these discs has a pull force of over 25 lbs.
--- End quote ---
Holy magnetic force Batman!
Sir Patrick:
This is what I used.
http://shop.hobbylobby.com/store/item.aspx?ItemId=160468
Leganoth:
--- Quote from: The Red Knight on 2011-09-08, 17:52:09 ---This is what I used.
http://shop.hobbylobby.com/store/item.aspx?ItemId=160468
--- End quote ---
Hmm i see, how strong are they? Do they hold well?
Sir Patrick:
Very strong. I literally have to pry my crest off the helm.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version